Zone X Occupancy Clear when Target Count > 0 & Occupancy Detected

[clintebbesen]

As seen in the screenshot below, on a daily basis I am having issues where the zone I am standing in says Occupancy = 'Clear', Target Count = 1, and the Overall occupancy sensor says 'Detected'. You can also see in the Zone Configurator it shows Target 1 active.

A few months ago I added 10mm gap between all zones, but it made no difference, still regularly having issues

I am running both the latest ESPHome (2024.10.3) and EST Lite (v1.2.0) firmware, I installed the non bluetooth proxy version.

Config:

[clintebbesen]

This has been regularly occurring, rebooting the esp fixes it for a little while.

[clintebbesen]

Similar issue I noticed today, except this time all of the occupancies were clear, target counts were all 0, but target 1 was actively tracking me while in zone 1

[fidesachates]

I just received my device and have noticed this as well.

[pkconnolly]

I'm having this same issue. Firmware: 1.2.0 (ESPHome 2024.11.0)

[montreyw]

Having the same issue. Reboot fixes it but wondering what the other options are.