Third Reality Humidity Sensor Update Not Found

[shall4]

Third Reality Humidity Sensor prompted an OTA update from v.30 to .47, but it fails with a 404.

[2025-01-11 15:57:44] info: z2m: Updating 'Laundry Humidity ' to latest firmware
[2025-01-11 15:58:56] info: z2m:mqtt: MQTT publish: topic 'zigbee2mqtt/Laundry Humidity ', payload '{"battery":100,"humidity":49.15,"linkquality":36,"temperature":20.3,"update":{"installed_version":30,"latest_version":47,"state":"available"}}'
[2025-01-11 15:58:56] info: z2m:mqtt: MQTT publish: topic 'zigbee2mqtt/bridge/response/device/ota_update/update', payload '{"data":{},"error":"Update of 'Laundry Humidity ' failed (Invalid response from https://github.com/Koenkk/zigbee-OTA/raw/master/images/ThirdReality/ThermalLiteSensor_PROD_OTA_V47_1.00.47.ota status=404.)","status":"error"}'
[2025-01-11 15:58:56] error: z2m: Update of 'Laundry Humidity ' failed (Invalid response from https://github.com/Koenkk/zigbee-OTA/raw/master/images/ThirdReality/ThermalLiteSensor_PROD_OTA_V47_1.00.47.ota status=404.)

[tyrel]

It looks like 47 was merged then reverted (reason unclear) but not completely.

See #648 (comment)

I'm curious if there's an intermediate version (46? 45?) that would be good to use if 47 is bad. Rather than going back to 30 (factory) or 29 (this repo).

[tyrel]

It appears that Third Reality has released version 56 to address the problem with 47.
https://3reality.com/release_note/temperature-and-humidity-sensor-lite/
How one gets that is unclear at this point.
FYI @weihuan1111

[Koenkk]

Should be fixed now, could you double check?

[1st-BrainStormer]

Seems to be one version older so can't check update. I Have 5 sensors 1 on Version 44(0x2C) and the other 4 on Version 30(0x1e) Guess we'll have to wait for third reality to make the update available. To bad they don't provide the link on their release notes page...

[shall4]

I checks as of this morning and a check for update. Installed version is 30 and the latest version is 29. Thanks for looking into it. I guess not much to do here; sensor seems to be working.