STAMPS SBAS execution overriding PS ps_plot dependencies

[PriyomRoy]

Hi,
I wish to flag an issue, not sure if any one else has faced it or it is specific to me, follows:
Once the PS workflow is executed and then ps_plot command is tried, all the plots are being generated and time series is also working fine. However, post the PS workflow, if one executes the SBAS, upon successful execution, a "SMALL BASELINE" sub folder is created. After this, if one attempts the ps_plot from the master folded (e.g. "INSAR_20220318) to generate the ps velocity, the following error is returned:

ps_plot('v')
Unrecognized field name "xy".
Error in ps_plot (line 325)
xy=ps.xy;

---

However, the command to generated SBAS velocity (i.e. ps_plot ('V')) from within the "SMALL BASELINE" sub folder is working fine.

[bspckishore]

Hi,
I have the same problem, Have you sorted this?

[alexisInSAR]

Hi,

I think there is a conflict between the EZ-InSAR figure environment and the figure generated by ps_plot. What is the situation if you close EZ-InSAR?

Kind regards,

Alexis

[bspckishore]

Hi Alexis,
The problem persists even after closing EZ-InSAR. But the same is working from SMALL BASELINE as mentioned by @PriyomRoy

[alexisInSAR]

Hi,

Was the PS processing carried out correctly?

Kind regards,

Alexis

[PriyomRoy]

Wish to update to 2.2.0. Do we need to run the entire workflow again or just few specific steps. pLease guide.

…

On Mon, Aug 21, 2023 at 2:05 PM Alexis Hrysiewicz ***@***.***> wrote: Hi, Was the PS processing carried out correctly? Kind regards, Alexis — Reply to this email directly, view it on GitHub <#57 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/A7WV6WM4E6LKGOJGFSQDIUTXWMMTXANCNFSM6AAAAAAZ5F4MRM> . You are receiving this because you were mentioned.Message ID: ***@***.***>

-- प्रियम रॉय Priyom Roy वैज्ञानिक Scientist SE भूविज्ञान ग्रुप Geosciences Group राष्ट्रीय सुदूर संवेदन केन्द्र National Remote Sensing Centre भारतीय अन्तरिक्ष अनुसंधान संगठन Indian Space Research Organisation हैदराबाद, भारत Hyderabad, India

[alexisInSAR]

You can use the new version with your previous data. It is not necessary to re-run the workflow.

[vittorio3d]

Hi,
I have the same problem with 2.2.1 Beta release, Have you solved it?

[alexisInSAR]

Hi Vittorio3d,

Please give me more information about this issue.

Kind regards,

Alexis

[Agupta662]

Hi,

Was the PS processing carried out correctly?

Kind regards,

Alexis

Hi @alexisInSAR , I completed the PS processing correctly and also plotted the results. However, once processing for SBAS, I am unable to plot PS results. I getting the same error as mentioned by @PriyomRoy .