-
Notifications
You must be signed in to change notification settings - Fork 184
/
rtw8703b.h
102 lines (90 loc) · 2.58 KB
/
rtw8703b.h
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
/* Copyright Fiona Klute <[email protected]> */
#ifndef __RTW8703B_H__
#define __RTW8703B_H__
#include "rtw8723x.h"
extern const struct rtw_chip_info rtw8703b_hw_spec;
/* phy status parsing */
#define VGA_BITS GENMASK(4, 0)
#define LNA_L_BITS GENMASK(7, 5)
#define LNA_H_BIT BIT(7)
/* masks for assembling LNA index from high and low bits */
#define BIT_LNA_H_MASK BIT(3)
#define BIT_LNA_L_MASK GENMASK(2, 0)
struct phy_rx_agc_info {
#ifdef __LITTLE_ENDIAN
u8 gain: 7;
u8 trsw: 1;
#else
u8 trsw: 1;
u8 gain: 7;
#endif
} __packed;
/* This struct is called phy_status_rpt_8192cd in the vendor driver,
* there might be potential to share it with drivers for other chips
* of the same generation.
*/
struct phy_status_8703b {
struct phy_rx_agc_info path_agc[2];
u8 ch_corr[2];
u8 cck_sig_qual_ofdm_pwdb_all;
/* for CCK: bits 0:4: VGA index, bits 5:7: LNA index (low) */
u8 cck_agc_rpt_ofdm_cfosho_a;
/* for CCK: bit 7 is high bit of LNA index if long report type */
u8 cck_rpt_b_ofdm_cfosho_b;
u8 reserved_1;
u8 noise_power_db_msb;
s8 path_cfotail[2];
u8 pcts_mask[2];
s8 stream_rxevm[2];
u8 path_rxsnr[2];
u8 noise_power_db_lsb;
u8 reserved_2[3];
u8 stream_csi[2];
u8 stream_target_csi[2];
s8 sig_evm;
u8 reserved_3;
#ifdef __LITTLE_ENDIAN
u8 antsel_rx_keep_2: 1;
u8 sgi_en: 1;
u8 rxsc: 2;
u8 idle_long: 1;
u8 r_ant_train_en: 1;
u8 ant_sel_b: 1;
u8 ant_sel: 1;
#else /* __BIG_ENDIAN */
u8 ant_sel: 1;
u8 ant_sel_b: 1;
u8 r_ant_train_en: 1;
u8 idle_long: 1;
u8 rxsc: 2;
u8 sgi_en: 1;
u8 antsel_rx_keep_2: 1;
#endif
} __packed;
/* Baseband registers */
#define REG_BB_PWR_SAV5_11N 0x0818
/* BIT(11) should be 1 for 8703B *and* 8723D, which means LNA uses 4
* bit for CCK rates in report, not 3. Vendor driver logs a warning if
* it's 0, but handles the case.
*
* Purpose of other parts of this register is unknown, 8723cs driver
* code indicates some other chips use certain bits for antenna
* diversity.
*/
#define REG_BB_AMP 0x0950
#define BIT_MASK_RX_LNA (BIT(11))
/* 0xaXX: 40MHz channel settings */
#define REG_CCK_TXSF2 0x0a24 /* CCK TX filter 2 */
#define REG_CCK_DBG 0x0a28 /* debug port */
#define REG_OFDM0_A_TX_AFE 0x0c84
#define REG_TXIQK_MATRIXB_LSB2_11N 0x0c9c
#define REG_OFDM0_TX_PSD_NOISE 0x0ce4 /* TX pseudo noise weighting */
#define REG_IQK_RDY 0x0e90 /* is != 0 when IQK is done */
/* RF registers */
#define RF_RCK1 0x1E
#define AGG_BURST_NUM 3
#define AGG_BURST_SIZE 0 /* 1K */
#define BIT_MASK_AGG_BURST_NUM (GENMASK(3, 2))
#define BIT_MASK_AGG_BURST_SIZE (GENMASK(5, 4))
#endif /* __RTW8703B_H__ */