Detection Sensor no longer working on the latest FW and Android App

[captainchaosrules]

Detection Sensor no longer working on the latest FW and Android App.
It's not sending alarms anymore after I upgraded on my Heltec V3.
2.3.13 works. 2.5.18 does not work.
Also tried 2.5.18 on the T114 and it's not working either.

[garthvh]

Are you trying to use the public channel? Needs to be a private channel.

[captainchaosrules]

Ah that's it then.
What is the latest version that allowed the use of the Public Channel?
Thanks

[captainchaosrules]

The drop down menu in iOS has pins 1-48. What are they mapped to?
I used Pin 8 GPIO33 for the input which goes low to high when motion is detected.
I am getting continuous triggers even when this pin is grounded.
Is there a better PIN to use?
Also the iOS says you need to enable it in client mode of the receiving device however my other device is an Android but I don't see a client option.

Thanks

[madeofstown]

Ah that's it then. What is the latest version that allowed the use of the Public Channel? Thanks

Please don't. There are reasons it was removed from the default public channels, the main one being that it spams the entire network. If you want detection sensors make your primary channel private please.

[captainchaosrules]

Roger that. Can anyone answer my question about the PIN mapping to the T114?

Thanks