Radiolink R16F failsafe

[sumeryamaner]

I have successfully bound Radiolink R16F receiver with my TX16S + 4 in 1 module. Everything works fine except the failsafe function. Radiolink system requires setting the failsafe at transmitter side and the information is being sent to the receiver about every 2 seconds. But in my TX16S, internal module page is missing the failsafe setup. Any ideas on how to setup failsafe in my situation?

Edit: I just found out that I can only use channels 1-8. Channels 9-16 are for transmitting fail safe settings for the channels 1-8. A big disappointment. As far as I can understand, there is no way to use the full channel range of R16F with a 4 in 1 module.

[pascallanger]

May be you should read the doc: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/blob/master/Protocols_Details.md#radiolink---74
Both Failsafe and extended range are explained. You can do the same as the original, you just need to read and configure the radio correctly...

[sumeryamaner]

I'm really sorry. I have read the info on your link but I could not understand how to activate ch9-16.