[BFW-6705] [BUG] Opening doors causes crash

[greggjaskiewicz]

Printer model

CoreOne

Firmware version

6.3.0

Upgrades and modifications

Noe

Printing from...

USB Drive

Describe the bug

Opening doors at some points causes either crash (probably triggering watch-dog, the way it behaves).
I found this happening either during initial warm up/bed mesh, or during final descent when print is done - and I'm eager to open the door!

Or on other occasions (probably should be separate bug) - throws UI dialog in the middle of another event. Picture running out of filament, and being prompted to confirm that correct colour has been observed. I want to then open the door and pinch away the excess - but dialog on the screen obstructs the new-filament query dialog. It's almost like door opening event has just been a last minute slap on top of the firmware.

How to reproduce

run print, and open the door either before print starts properly or when it finishes and bed descends down Z - to lower position.

Expected behavior

Opening the door shouldn't cause everything to crash or other higher priority (such as filament reload) dialogs should not give way to it.

IMG_2778.mp4

Files

No response

[CZDanol]

Hello, thank you for reporting. At least the printer restart at the end should be fixed in 6.3.1. Internal ticket: BFW-6705