You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Note> This was not observed with v1.7.7. I have not installed any of the intervening builds.
When using the webapp to set keyframes. it is possible to set a value, in degrees, for the movement of the motor. However the actual movement seems to be 4x the entered value e.g. if I specify 5deg for the PAN axis and press the left (resp. right) arrow, the actual motion is 20 deg.
I did select NMX as the type in the pull-down.
When running a timelpase, the motor seems to be moving correctly. as it reaches the keyframe in the prescribed time. So this problem seems to be limited to the keyframe setup dialog. BT is being used for the communications between the NMX and the View.
Jeremy Brookfield
The text was updated successfully, but these errors were encountered:
This sounds like it might be an issue with the microstepping setting for that motor on the NMX. The VIEW doesn't actually set this, so you'll want to check it in the Dynamic Perception app. I need to check to see what the default should be -- I'm not sure at the moment. Also, just so you're aware, if you're using the NMX with bluetooth, I highly recommend updating the VIEW to the latest firmware as I've many bugfixes and improvements to the NMX driver and motion system.
Note> This was not observed with v1.7.7. I have not installed any of the intervening builds.
When using the webapp to set keyframes. it is possible to set a value, in degrees, for the movement of the motor. However the actual movement seems to be 4x the entered value e.g. if I specify 5deg for the PAN axis and press the left (resp. right) arrow, the actual motion is 20 deg.
I did select NMX as the type in the pull-down.
When running a timelpase, the motor seems to be moving correctly. as it reaches the keyframe in the prescribed time. So this problem seems to be limited to the keyframe setup dialog. BT is being used for the communications between the NMX and the View.
Jeremy Brookfield
The text was updated successfully, but these errors were encountered: