(solved) Battery voltage too high

[Basnl80]

Hello,

My voltage is too high. The reading in my Ispindle is 5,34V. When I measure it it's 4,15V and that's too much for the conversation factor of 246,80. Is there anything what I can do?

[wilbrod]

Check the resistors on your iSpindel, they're either wrong size or need to be swapped out.

…

On Wed, Dec 28, 2022, 11:13 Basnl80 ***@***.***> wrote: Hello, My voltage is too high. The reading in my Ispindle is 5,34V. When I measure it it's 4,15V and that's too much for the conversation factor of 246,80. Is there anything what I can do? — Reply to this email directly, view it on GitHub <#596>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABQB5MOPNB3RWURYSFZP4VTWPR7ONANCNFSM6AAAAAATLOYDNM> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[Basnl80]

Ik measure 4.7k ohm and 183k ohm. The 183 need to be 220k ohm right?

[wilbrod]

That's correct. Color code for it is : Red-red-black-orange and a 5th color for tolerance. Not sure if 183k would be sufficient or in which way it affects the iSpindel but make sure they're soldered in the right spot and you didn't mix up their spot on the board you're using.

…

On Wed, Dec 28, 2022, 12:19 Basnl80 ***@***.***> wrote: Ik measure 4.7k ohm and 183k ohm. The 183 need to be 220 ohm right? — Reply to this email directly, view it on GitHub <#596 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABQB5MP5VKJG7L7FRD5B7DTWPSHFPANCNFSM6AAAAAATLOYDNM> . You are receiving this because you commented.Message ID: ***@***.***>

[Basnl80]

The resistors are on the right place. Soo it's looks like the 184k ohm is the problem

[universam1]

yep, it should be 220k

[Basnl80]

Thanx everybody, the 220k resistor was the problem. The color code says 220k but after remove it it's measured 215k. If placed a new 220k and nu it's works great.