Build and install

Dependencies

These are the minimum requirements to build the driver:

• gcc
• make
• linux-headers >= 3.16.0

Additional tools that may be useful for development:

• libelf
• kmod
• sparse
• Qt Creator

Build and install

You can build and install akvcam with the following commands:

cd akvcam/src
make
sudo make install

It may return some warnings about unknown symbols in depmod, don't worry, the driver will work without problems. You can check the driver is installed with:

ls /lib/modules/$(uname -r)/extra/akvcam.ko*

And you can uninstall the driver with:

sudo make uninstall

To load the module on boot you must add akvcam to /etc/modules file, and then run:

sudo depmod

Build flags

• KERNEL_DIR: The path where kernel source are located. Default to /lib/modules/$(shell uname -r)/build.
• DESTDIR: The install prefix of the driver, used with make install. Default to /.
• USE_SPARSE=1: Use sparse to check for errors in source files when building.
• SPARSE_MODE: Mode 1 only check errors when the source file is modified, mode 2 check errors every time the driver is built. Default to 2.

Build and develop with Qt Creator

You can open the driver source code as a normal Qt project, to do so just open the akvcam.pro file with Qt Creator and that's it. Qt Creator offers a lot of nice and modern features to improve driver development like static code parsing, error, warning and source tracking, and a lot more.