smol fixes, mainly skill issues

DefenderOfHyrule · Jun 23, 2024 · bb00b56 · bb00b56
1 parent 783e068
commit bb00b56
Show file tree

Hide file tree

Showing 2 changed files with 3 additions and 3 deletions.
diff --git a/docs/modchip/lite.md b/docs/modchip/lite.md
@@ -19,7 +19,7 @@ These values can differ from console to console. If your modchip installation wo
 | **SP2** `~0.12`           | **SP2** `~0.10`              |
 | **A** (CMD) `~0.470`      | **A** (CMD) `~0.875`         |
 | **B** (RST) `~0.405`      | **B** (RST) `OL`             |
-| **C** (DAT0) `~0.435`     | **C** (DAT0) `~0.500-0.850`  |
+| **C** (DAT0) `~0.435`     | **C** (DAT0) `~0.450-0.850`  |
 | **D** (CLK) `~0.440`      | **D** (CLK) `~0.880`         |
 | **3.3v** `~0.445`         | **3.3v** `~0.850`            |
 
@@ -118,7 +118,7 @@ These values can differ from console to console. If your modchip installation wo
       ![ihs-modified](/img/lite_img/ihs-modified.JPG)
 
 16.  Once done, connect the ribbon cable to the port on the modchip by bending the SoC ribbon cable accordingly. (Be careful!)
-       - **Optional:** At this point, you can test if your modchip installation was successful. Re-connect the battery and turn the console on, you should end up at a `No SD Card` splash screen with the Picofly logo.
+       - **Optional:** At this point, you can test if your modchip installation was successful. Re-connect the battery and the screen ribbon cable, then turn the console on. You should end up at a `No SD Card` splash screen with the Picofly logo.
 
        ![test](/img/lite_img/test.JPG)
 

diff --git a/docs/modchip/oled.md b/docs/modchip/oled.md
@@ -149,7 +149,7 @@ Solder a wire to the `B` point and solder the other end of the wire to the `B` p
 27. Place a piece of double sided tape on top of the RAM section of the IHS, then place the modchip on top of it to secure it in place. Make sure no components (such as the SoC ribbon cable and wires you soldered onto the modchip) are under any kind of stress when doing this.
 ![test-setup-2](../img/oled_img/test-setup-2.JPG)
 
-28. Your Switch should now look like the image below. If it does, you can re-connect the battery connector, power button board and screen ribbon cable and power the console on after the the modchip glitches and trains (blinks blue, then white). You should be greeted with the `No SD Card` splash screen with the Picofly logo.
+28. Your Switch should now look like the image below. If it does, you can re-connect the battery connector, power button board and screen ribbon cable and power the console on after the modchip glitches and trains (blinks blue, then white). You should be greeted with the `No SD Card` splash screen with the Picofly logo.
 ![test-setup-2](../img/oled_img/test-setup-2.JPG)
 ![test-setup-3](../img/oled_img/test-setup-3.JPG)