GF30 settings updated.

resources/quality/z-bolt/GF/z-bolt_GF30_v6_0.40.inst.cfg

@@ -0,0 +1,47 @@
+[general]
+version = 4
+name = GF-30
+definition = z-bolt_base
+
+[metadata]
+setting_version = 19
+type = quality
+quality_type = GF-30
+material = generic_tpu
+variant = E3DV6 0.40mm
+
+[values]
+speed_print = 70
+top_layers = 6
+bottom_layers = 4
+wall_line_count = 4
+top_bottom_thickness = 1.6
+infill_sparse_density = 100
+infill_pattern = lines
+cool_fan_full_at_height = 0.7
+cool_fan_full_layer = 10
+cool_fan_speed = 100
+cool_min_layer_time = 40
+cool_min_layer_time_fan_speed_max = 30
+cool_min_speed = 5
+material_flow = 97
+retraction_count_max = 25
+retraction_extrusion_window = 1
+retraction_hop = 2
+retraction_hop_enabled = True
+retraction_hop_only_when_collides = True
+retraction_speed = 10
+support_angle = 70
+support_brim_enable = True
+support_brim_width = 4
+support_infill_rate = 10
+support_interface_enable = True
+support_interface_height = 0.6
+support_interface_line_width = 0.36
+support_line_width = 0.36
+support_wall_count = 1
+support_xy_distance = 1
+support_xy_distance_overhang = 0.4
+support_z_distance = 0.12
+travel_avoid_distance = 3
+travel_avoid_supports = True

resources/quality/z-bolt/GF/z-bolt_GF30_v6_0.40_good.inst.cfg → resources/quality/z-bolt/z-bolt_global_0.16_GF30.inst.cfg

@@ -6,8 +6,9 @@ definition = z-bolt_base
 [metadata]
 setting_version = 19
 type = quality
-quality_type = good
-material = generic_tpu
-variant = E3DV6 0.40mm
+quality_type = GF-30
+global_quality = True
 
 [values]
+layer_height = 0.16
+adhesion_type = brim