DMS

Detector motion system

Setup

In your config folder, set up a file NDWxxxx\configurations\galil\axes.cmd with the following content:

$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=DISK:BEAMSTOP1:X,mAXIS=MTR0101")
$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=DISK:BEAMSTOP1:Y,mAXIS=MTR0102")
$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=DISK:BEAMSTOP2:X,mAXIS=MTR0103")
$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=DISK:BEAMSTOP2:Y,mAXIS=MTR0104")
$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=STRIP:BEAMSTOP,mAXIS=MTR0105")
$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=DETECTORS,mAXIS=MTR0106")
$(IFDMC01) dbLoadRecords("$(AXIS)/db/axis.db","P=$(MYPVPREFIX)MOT:,AXIS=BAFFLE,mAXIS=MTR0107")

This allows us to create "aliases" for the DMS axes. It assumes we are using IOC GALIL_01. If using GALIL_0n, change IFDMC01 to IFDMC0n and MTR010m to MTR0n0m (i.e. MTR0101 becomes MTR0201 for n=2). Unless otherwise stated, we'll assume we're working with GALIL_01.

Don't forget the new line at the end of the file or the final line will not be processed and the Baffle will appear disconnected.

Start GALIL_01. Don't forget to set the appropriate macros.

Create a synoptic with component detector motion system, no synoptic macros are required.